# convert degrees, minutes, and seconds into feet

Questions and answers on how to convert things from one unit or system to another
Forum rules
Dear convert-me.com forum visitors,

Our forum has been available for many years. In September 2014 we decided to switch it to read-only mode. Month after month we saw less posts with questions and answers from real people and more spam posts. We were spending more and more resources cleaning the spam until there were less them 1 legitimate message per 100 spam posts. Then we decided it's time to stop.

All the posts in the forum will be available and searchable. We understand there are a lot of useful information and we aren't going to remove anything. As for the new questions, you can always ask them on convert-me.com FaceBook page

Thank you for being with us and sorry for any inconveniences this could caused.

### convert degrees, minutes, and seconds into feet

How do you convert from degrees, minutes, and seconds into feet and inches?
david364

I know this one...

I presume you are measuring the length of an arc or curve between two points. You need to know the radius or the arc you are trying to measure the length of.

then it just a case of using this formula:

L = (A / 360) x (2 x pi x r)
where L-Length, A=Angle, pi=3.14..., r=radius of the circle.

Also, there are 60seconds in a minute and 60minutes in a degree (360sec in a degress). And 1 foot = 12inches, and approx 0.0394mm in one inch.

Its probably easier to work in metric (ie mm or meters) to be honest. Find the radius in mm, calculate the arc length L in mm, convert into inches, then divide by 12 for the number of whole feet, then simply multiply the decimal remainder by 12 for the number of remainder inches.

Hope this helps.
Phil57

### Re: convert degrees, minutes, and seconds into feet

Bending Metal.
3" height by 1.5" Length with a 3/4" angle
What is the degree of the bend?
suzanneo

### Re: convert degrees, minutes, and seconds into feet

suzanneo wrote:Bending Metal.
3" height by 1.5" Length with a 3/4" angle
What is the degree of the bend?

The angle (Theta) is 28.9550 decimal degrees, measured by the chord length of 3/4â€ť (point on arc to point on arc), which forms an Isosceles triangle.

The formula is: Theta = arcsine (0.5 * opposite side / hypotenuse)) * 2, so:

Theta = arcsine (0.5 * 0.75â€ť /1.5â€ť)) * 2;
Theta = arcsine (0.375 /1.5)) * 2;
Theta = arcsine (0.25)) * 2;
Theta = 14.477512 * 2;
Theta = 28.9550Âş or in DMS format: 28Âş 57â€™ 18â€ť
Dirtman
Expert

Posts: 574
Joined: Sat Jan 21, 2006 2:04 pm
Location: California