I'm hoping someone can help me with this,
According to HES A3035 (This is an automotive specification for a peel test of a laminate on a plastic substrate)
The peel test result should be 25kgf minimum.
My test samples are 25mm. x 150mm. My question is: what is the minimum result I can get for an acceptable part? I came up with .28kg.
Thanks in advance for any help!
Convert-Me.Com - online units conversion
Instant conversion pages: weight, length, volume, weight to volume, area, cooking, pressure, more...
Need help problem solving
Forum rules
Dear convert-me.com forum visitors,
Our forum has been available for many years. In September 2014 we decided to switch it to read-only mode. Month after month we saw less posts with questions and answers from real people and more spam posts. We were spending more and more resources cleaning the spam until there were less them 1 legitimate message per 100 spam posts. Then we decided it's time to stop.
All the posts in the forum will be available and searchable. We understand there are a lot of useful information and we aren't going to remove anything. As for the new questions, you can always ask them on convert-me.com FaceBook page
Thank you for being with us and sorry for any inconveniences this could caused.
Dear convert-me.com forum visitors,
Our forum has been available for many years. In September 2014 we decided to switch it to read-only mode. Month after month we saw less posts with questions and answers from real people and more spam posts. We were spending more and more resources cleaning the spam until there were less them 1 legitimate message per 100 spam posts. Then we decided it's time to stop.
All the posts in the forum will be available and searchable. We understand there are a lot of useful information and we aren't going to remove anything. As for the new questions, you can always ask them on convert-me.com FaceBook page
Thank you for being with us and sorry for any inconveniences this could caused.
2 posts
• Page 1 of 1
Need help problem solving
by Jam » Thu May 13, 2004 10:43 pm
- Jam
- Posts: 1
- Joined: Thu May 13, 2004 10:33 pm
Re: Need help problem solving
by Knight » Fri May 14, 2004 1:47 am
Can you give some more information about the conditions of the test? I did a search for HES A3035, but was unable to find any reference to it on the webJam wrote:I'm hoping someone can help me with this,
According to HES A3035 (This is an automotive specification for a peel test of a laminate on a plastic substrate)
The peel test result should be 25kgf minimum.
My test samples are 25mm. x 150mm. My question is: what is the minimum result I can get for an acceptable part? I came up with .28kg.
Thanks in advance for any help!
- Knight
- Expert
- Posts: 309
- Joined: Tue Jan 13, 2004 9:43 pm
- Location: Los Alamos, NM
More info
2 posts
• Page 1 of 1