how to figure out cubic yds. in a coned shape pile of dirt.

Don't know how to calculate the area of your garden or circumference of a pond? Ask your question here.
Forum rules
Dear convert-me.com forum visitors,

Our forum has been available for many years. In September 2014 we decided to switch it to read-only mode. Month after month we saw less posts with questions and answers from real people and more spam posts. We were spending more and more resources cleaning the spam until there were less them 1 legitimate message per 100 spam posts. Then we decided it's time to stop.

All the posts in the forum will be available and searchable. We understand there are a lot of useful information and we aren't going to remove anything. As for the new questions, you can always ask them on convert-me.com FaceBook page

Thank you for being with us and sorry for any inconveniences this could caused.

how to figure out cubic yds. in a coned shape pile of dirt.

Postby waste99 » Thu Aug 07, 2008 12:04 am

I have several large piles of smashed concrete and soil combined, I need to figure out the formula to find cubic yards and tonnage. they are cone shaped, round at the base up to the point. I need to give a vendor a basic estimate.
waste99
 

Re: how to figure out cubic yds. in a coned shape pile of di

Postby Dirtman » Thu Aug 07, 2008 9:19 am

waste99 wrote:I have several large piles of smashed concrete and soil combined, I need to figure out the formula to find cubic yards and tonnage. they are cone shaped, round at the base up to the point. I need to give a vendor a basic estimate.


The formula for the volume of a cone is: (PI*radius squared*height)/3

Using feet, the answer is in ft^3. Divide bt 27 to get yd^3. This will be an approximate value in loose cubic yards as compaction isn't known. If the stockpiles are recent it should be close but I would add 2% minimum to the total for compaction in place.

Tonnage can vary considerably depending on density of materials and moisture. Broken concrete will weigh comparably to broken limestone, about 95-100 pcf (pounds ft^3) and clay or pit-run sand and gravel can weigh over 110 pcf if wet.

If the stockpiled material is reasonably dry, 2835 per lcy (loose cubic yard) would probably be a decent approximation to use, which is 1.42 tons per lcy.

For your own calcs, here is a weights of materials chart: http://www.reade.com/Particle_Briefings/spec_gra2.html
Dirtman
Expert
 
Posts: 574
Joined: Sat Jan 21, 2006 2:04 pm
Location: California


More info

  • List of all units you can convert online
  • Metric conversion
  • Convert pounds to gallons
  • Convert grams to cups
  • Grams to milliliters
  • Imperial vs US Customary
  • History of measurement
  • Return to Calculating things



    Our Privacy Policy       Cooking Measures Converter       Metric conversions

    cron