Sheet Metal Gauge
Posted: Thu Apr 15, 2004 9:45 pm- Conversion from sheet metal gauge to decimal, fractional, inches & mm
Convert-Me.Com - online units conversion
Measurements Conversions, Metric Conversions
http://www.convert-me.com/en/bb/
Sheet Metal Gauge
Page 1 of 1
Posted: Thu Apr 15, 2004 9:45 pmRe: Sheet Metal Gauge
Posted: Mon Mar 21, 2005 10:03 pmKen Magar wrote:Conversion from sheet metal gauge to decimal, fractional, inches & mm
looking for conversion of 24 guage to inches
Posted: Mon Mar 21, 2005 10:43 pmUse the sheet steel column at this page:
http://www.engineersedge.com/gauge.htm
I googled several sources and they seem to agree on 0.239"
for US gauge. If British, probably the Birmingham or Stubbs gauge for steel, but I'm not sure of that. Browne & Sharp is used for nonferrous metal and is also the basis for American Wire gauge AWG
http://www.engineersedge.com/gauge.htm
I googled several sources and they seem to agree on 0.239"
for US gauge. If British, probably the Birmingham or Stubbs gauge for steel, but I'm not sure of that. Browne & Sharp is used for nonferrous metal and is also the basis for American Wire gauge AWG
Re: Sheet Metal Gauge
Posted: Wed Apr 06, 2005 1:19 am, 16 guage, 18 guage, 14 guage, 13 guageAnonymous wrote:Ken Magar wrote:Conversion from sheet metal gauge to decimal, fractional, inches & mm
looking for conversion of 24 guage to inches
Re: Sheet Metal Gauge
Posted: Tue Mar 05, 2013 11:18 am