:? Need to convert metal guage (20) to mm.
Help!!
Convert-Me.Com - online units conversion
Instant conversion pages: weight, length, volume, weight to volume, area, cooking, pressure, more...
Guages to mm
Forum rules
Dear convert-me.com forum visitors,
Our forum has been available for many years. In September 2014 we decided to switch it to read-only mode. Month after month we saw less posts with questions and answers from real people and more spam posts. We were spending more and more resources cleaning the spam until there were less them 1 legitimate message per 100 spam posts. Then we decided it's time to stop.
All the posts in the forum will be available and searchable. We understand there are a lot of useful information and we aren't going to remove anything. As for the new questions, you can always ask them on convert-me.com FaceBook page
Thank you for being with us and sorry for any inconveniences this could caused.
Dear convert-me.com forum visitors,
Our forum has been available for many years. In September 2014 we decided to switch it to read-only mode. Month after month we saw less posts with questions and answers from real people and more spam posts. We were spending more and more resources cleaning the spam until there were less them 1 legitimate message per 100 spam posts. Then we decided it's time to stop.
All the posts in the forum will be available and searchable. We understand there are a lot of useful information and we aren't going to remove anything. As for the new questions, you can always ask them on convert-me.com FaceBook page
Thank you for being with us and sorry for any inconveniences this could caused.
2 posts
• Page 1 of 1
Re: Guages to mm
by Knight » Sat Jun 12, 2004 1:58 am
I.Y. Elect wrote::? Need to convert metal guage (20) to mm.
Help!!
For sheet steel, 20 gauge would be 0.9119 mm.
For Galvanized Steel, 20 Gauge would be 1.0058 mm
For aluminum, 20 gauge would be 0.8128 mm.
You can find a good conversion calculator at http://www.onlineconversion.com/gauge_sheet_metal.htm
- Knight
- Expert
- Posts: 309
- Joined: Tue Jan 13, 2004 9:43 pm
- Location: Los Alamos, NM
More info
2 posts
• Page 1 of 1